loading  Loading... Please wait...

Tray-Rectangle Soap Mold

  • Tray-Rectangle Soap Mold
  • Tray-Rectangle Soap Mold
SKU:
SM-179
Shipping:
Calculated at checkout
RRP:
$8.95
$7.93 (You save $1.02)
**Price after discount is applied at checkout.

    Product Description

    Tray-Rectangle Soap Mold

    Dimensions: 4 x 2 x 1
    Number of Cavities: 
    Ounces: 4 each

    The classics never go out of style and our Tray Rectanlge soap mold will make eight robust rectangular soaps.

    Milky Way Soap Molds can tolerate temperatures of 135-145 degrees F. Above these temperatures, warping may occur. Soap is easiest to release 12-24 hours after cooling. 

     

     

     

    This high quality Tray-Rectangle Soap Mold is great for for making custom soaps, candle tarts and countless other craft projects. Mold #179

    Find Similar Products by Category

    Write a Review

    Product Reviews

    Disclaimer: While we work to ensure that product information is correct, WE DO NOT MONITOR REVIEWS FOR ACCURATE INFORMATION. WE STRONGLY INSIST THAT YOU DO NOT TAKE MEDICAL ADVICE FROM ANY REVIEWS OR ASSUME THAT A PRODUCT WILL WORK THE SAME FOR YOU AS IT DID FOR OTHERS. Every consumer is different, circumstances vary and interpretations of results vary. These reviews allow consumers to share their experience with products but WE DO NOT VERIFY THE LEGITIMACY OF REVIEWS. These reviews are not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. You should not use this information as self-diagnosis or for treating a health problem or disease. Contact your health-care provider immediately if you suspect that you have a medical problem. Information and statements have not been evaluated by the Food and Drug Administration and are not intended to diagnose, treat, cure, or prevent any disease or health condition. BulkApothecary.com assumes no liability for inaccuracies or misstatements about products in these reviews.

    1. Look Closely 3 star review

      Posted by on

      This is a plastic mold, not a silicon mold. The picture description is what is created after you take it out of the mold. This mold is easy to use. You need to do cold process in order to really use this mold because of the heat hot process will warp the mold. The bars sometimes stick to the mold when your ready to remove them but they look good and you need to cut them in the provided areas they turn out to be a little less than 4oz so why not make a mold to accommodate this issue? When you get a 4oz mold it would to get a 4oz bar


    2. Great 5 star review

      Posted by on

      Good quality mold, not like the ones you would buy from chain hobby stores.