15% OFF ORDERS OVER $250
Automatically at Checkout
Dimensions: 3.75 x 3 x 1.125
Number of Cavities: 3
Now you can massage your skin while bathing! Our Massage Egg soap mold has raised, rounded nubs that deliver an invigorating, soapy experience while you wash. It's like going to a spa without leaving your home.
Milky Way Soap Molds can tolerate temperatures of 135-145 degrees F. Above these temperatures, warping may occur. Soap is easiest to release 12-24 hours after cooling.
This high quality Massage Egg Soap Mold is great for for making custom soaps, candle tarts and countless other craft projects. Mold #157
Disclaimer: While we work to ensure that product information is correct, WE DO NOT MONITOR REVIEWS FOR ACCURATE INFORMATION. WE STRONGLY INSIST THAT YOU DO NOT TAKE MEDICAL ADVICE FROM ANY REVIEWS OR ASSUME THAT A PRODUCT WILL WORK THE SAME FOR YOU AS IT DID FOR OTHERS. Every consumer is different, circumstances vary and interpretations of results vary. These reviews allow consumers to share their experience with products but WE DO NOT VERIFY THE LEGITIMACY OF REVIEWS. These reviews are not intended to substitute for advice given by a physician, pharmacist, or other licensed health-care professional. You should not use this information as self-diagnosis or for treating a health problem or disease. Contact your health-care provider immediately if you suspect that you have a medical problem. Information and statements have not been evaluated by the Food and Drug Administration and are not intended to diagnose, treat, cure, or prevent any disease or health condition. BulkApothecary.com assumes no liability for inaccuracies or misstatements about products in these reviews.
Posted by Jacqueline Todd on 24th Apr 2017
I love this new mold! I tested it with a melt and pour olive oil glycerin soap. I used a pearl mica colorant and they are gorgeous! Each soap weighs approximately 5.3 ounces and the mold itself is quite sturdy. Be patient and gentle with the mold because it is a hard plastic.
Posted by Stephanie Ingram on 10th Oct 2016
Great massage bar mold. Wish it had 4 cavities. Soap was a little difficult to remove even after placing it in the freezer for a while. Overall was what I wanted.
I will definitively order another one.
Posted by Pysanky Pittsburgh on 10th Dec 2015
I bought this mold to experiment in making pysaky soaps. I would have preferred a flat mold, but this is OK. It is exactly as shown (it is clear though, with three molds on one 'square').